Would someone please tell me how to step-by-step remove the passenger front door panel on a 2010 Prius without doing any damage? Thank you.
The technical sub-forum will be probably better for this kind of question. [FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold]REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG - 3 claws on perimeter[/FONT][/FONT][/FONT] [FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold]REMOVE ASSIST GRIP COVER - 6 claws, 2 clips on perimeter[/FONT][/FONT][/FONT][/FONT][/FONT][/FONT] [FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold]REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL 7 claws on perimeter, disconnect the connetor[/FONT][/FONT][/FONT][FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold] [*]REMOVE DOOR ARMREST COVER[/FONT][/FONT][/FONT][FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold] [*]REMOVE COURTESY LIGHT ASSEMBLY - 1 claw at short edge on right side[/FONT][/FONT][/FONT][FONT=Verdana,Bold][FONT=Verdana,Bold][FONT=Verdana,Bold] [*]REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY - many clips around perimeter Don't worry too much about the damage. the plastics are quite durable. Use the plastic clip/molding remover. Usually when you insert the plastic remover between parts, you will see where to pull. Toyota recommends to disconnect the '-' (black) pole of the battery in the cargo area usually, but it is not a must if you are far away from the airbag locations.[/FONT][/FONT][/FONT]
