Does anyone have a diagram for replacing a side mirror? I've read the threads about how to replace them, but if there was a cutaway view or diagram, it would sure make my job easier. I have a 2007 Prius, a replacement mirror, and the desire to fix it myself. I just do much better if I can visual the job at hand. Thanks for any help.
Can;t paste pictures here, but: REMOVALHINT: • Use the same procedures for the RH side and LH side. • The procedures listed below are for the LH side.1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. 2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (See page ED-11) 3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH (See page ED-11) 4. REMOVE DOOR PULL HANDLE (See page ED-11) 5. REMOVE FRONT ARMREST UPPER BASE PANEL LH (See page ED-11) 6. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY LH (See page ED-12) 7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH (See page MI-9) 8. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH (a) Put protective tape under the moulding. (b) Using a moulding remover, detach the claws to remove the moulding as shown in the illustration. HINT: Tape the remover tip before use.Moulding Remover Protective TapeB074194E02EXTERIOR – FRONT DOOR BELT MOULDING ET–21 ETINSTALLATIONHINT: • Use the same procedures for the RH side and LH side. • The procedures listed below are for the LH side.1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH(a) Attach the claws to install the moulding. HINT: Confirm that the moulding is firmly installed.2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH (See page MI-13) 3. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY LH (See page ED-21) 4. INSTALL FRONT ARMREST UPPER BASE PANEL LH (See page ED-21) 5. INSTALL DOOR PULL HANDLE (See page ED-22) 6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH (See page ED-22) 7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH (See page ED-22) 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 9. PERFORM INITIALIZATION (a) Perform initialization (see page IN-32). NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable fromthe negative (-) battery terminal.
Thanks Vertex - that has more info than I had before.. is there a website for this info you gave for viewing the pix?
There is another thread answering the same question: http://priuschat.com/forums/gen-ii-...hooting/58015-how-replace-drivers-mirror.html
[ Marnius'prius, I'm not sure if you are still in need of a side view mirror diagram but I found a simple from 2007 Toyota PRIUS 10622 87-01 Mirror Parts | Genuine OEM Toyota Parts: Let me know if you have any questions with the job!
