Have code POAOf. 204 engine done 90,v000 miles ran okay but started splutering then seemed to clear up and ran okay . Parked up tried to start now won't start ran techstream got above codes plus PO335" CRANKSHAFT SENSOR A CIRCUIT I FILLED PETROL UP NOW SHOWING UP TO BAR 4. ANY ADVICE WOULD HELP ALSO WERE IS THE FUEL PUMP. RELAY CLEANED MAFF AND THROTTLE BODY STILL WILL NOT START
what does the 12v read on a digital volt meter at the jump point under the hood, after having been off for 6 hours
Left car overnight got. 12 volt reading readings taken from fusebox Following codes POAOf .524 engine failed to start PO11 engine coolant temperature circuit high input PO335 crankshaft position sensor A circuit Have changed maff sensor Changed crankshaft sensor Cleaned throttle body Cleared codes tried to start get a very slow turning whirl sound maybe electric motor starts for about 2 to 5 seconds then stops Then ran ts again same codes reappear check hybrid sign goers off for a few seconds then reappears
Yes ts being used following codes POAOf 204 po118 and po335 Cleared same codes came back up I took throttle body off found oil cleaned oil , out still did not start ready sign comes on
you can access the service manual at techinfo.toyota.com there will be troubleshooting that works in conjunction with tech stream
