To cut to the chase...do the thermostats function like all the others I know of? Full open or full closed are the only two possibilities or is there now a partial open function? TIA!
The thermostat operates on a termanally sensitive spring. It softens when it warms up; allowing fluid pressure on the other side to pass as it gets up to the designated temperature. Any contaminants or rust can impair it's operations. (ie. get it stuck closed, open, or partially open) Hope this help
If you're talking about the one in the hose elbow down by the water pump, I think it functions like all the others I know of. A spring holds it closed, and a pellet of wax trapped in a cylinder expands with heat and pushes it open. It's a slowish effect, nothing sudden about it. The thermostat starts to lift a bit above 80 ℃, definitely opening by 85 ℃. It should be fully open (10 to 14 mm lift) by 95 ℃. House thermostats on the wall, now those frequently are just on / off (though even that has been changing in these modern days of variable-rate furnaces, A/Cs, and heat pumps),
Car has 152,000 miles. Yep, looking at the engine t-stat. I was headed to Denver when I got the dreaded coolant dummy light that turns off quickly on a long steep climb out of Phx on a very hot day. I usually push the engine to the pwr section during these climbs but after that I backed off and crawled up with the slower vehicles. Everything was fine until the final long steady climb on I-70 right before the descent into the Denver area and then it came on again and did its thing so I backed off and made sure to stay out of the pwr range. Did some research and changed the water pump in Denver. Drove all around the Denver area for a week without issue. Drove home via I-25 and I-40 route at 80 mph with no issues until the final climb into the Flagstaff area on I-40 which is not steep but long and constant. Same thing, light on/off so I again went to staying out of the pwr area. Did the same thing and crawled up the last but very steep climb on I-17 out of Camp Verde and never saw the light. So now that I am home and have all my tools available it is time to figure it out. I just purchased a reader and used it all day yesterday and the temps never got above 195 F. (On a side note the strange thing was that on the first trip it gave me the water pump rpm stats but nothing since. I've read that it normally doesn't read the rpm.) So now I'm thinking the thermostat may not be opening fully since it seems that it only happens in extreme engine use and what I can only assume is the upper temps of the t-stat range.
