Best spark plugs for 05 Prius

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by shepdawg, May 14, 2014.

  1. douglasjre

    douglasjre Senior Member

    Joined:
    Sep 13, 2008
    2,121
    705
    0
    Location:
    Null, NL
    Vehicle:
    2010 Prius
    Model:
    ----USA----
    Chinese fakes from Amazon will grenade your engine
     
    Metrolens likes this.
  2. T1 Terry

    T1 Terry Active Member

    Joined:
    Jan 4, 2015
    819
    425
    0
    Vehicle:
    2006 Prius
    Model:
    Plug-in Advanced
    I very recently replaced both the plugs and coils on my V10 6.8 ltr Ford chassis motorhome. Near fell off my rocking chair at the cost, the plugs were more than the coils :eek: ...... but chalk and cheese on the first hill, and even on start up. The old ones had done 176,600 kms (roughly 110,000 mile).

    Remember to put some thread lubricant on the plugs befor you install them, they will be there for the next 100,000 miles so you don't want the thread coming out with the plug .....
    The gen 2 1500 goes for ever, if you look after it, my ex taxi Prius had 750,000kms on it, it wasn't the motor that took it off the road, needed parts for my other Prius on a holiday weekend where no one had front pads and rotors .... then the new NiMh battery got transferred to the other Prius ..... and that was about the end of it going back on the road ....

    T1 Terry
     
  3. Mendel Leisk

    Mendel Leisk MMX GEN III

    Joined:
    Oct 17, 2010
    59,205
    40,755
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Not knowing for sure if they’ve ever been changed, yeah change them. Instead of gambling to save a few bucks, get them from dealership or reputable, local auto supply place. Stick to the stock plug (spec’d in owner’s manual, and attached).

    Repair Manual makes no mention of lube, and it complicates things, specifically torque.

    You can check the gap, but the plug manufacturers recommend to not adjust. If it’s off they might have been dropped or something.

    In particular when installing the new plugs, if you’ve got an especially grippy spark plug socket, it’s prudent to tape the extension to socket, otherwise the socket may stay on the plug when try to pull it off.
     

    Attached Files:

    #23 Mendel Leisk, Aug 14, 2025 at 9:05 AM
    Last edited: Aug 14, 2025 at 9:17 AM
    Metrolens likes this.
  4. T1 Terry

    T1 Terry Active Member

    Joined:
    Jan 4, 2015
    819
    425
    0
    Vehicle:
    2006 Prius
    Model:
    Plug-in Advanced
    Non lubricated threads can affect torque reading, but not lubricated threads, the torque for tightening anything is based on clean lubricated threads ...... that includes wheel nuts/studs, lubricated threads or the taper being lubricated has nothing to do with the nut/stud remaining tight, it is the applied clamping effort and that can only occur with clean lubricated threads

    T1 Terry
     
  5. dolj

    dolj Senior Member

    Joined:
    May 14, 2012
    8,272
    4,217
    0
    Location:
    Wellington, New Zealand
    Vehicle:
    2007 Prius
    Model:
    N/A
    The threads on spark plugs (Denso and NGK, at least) are lubricated at the factory, so there should be no need to add more.
     
  6. T1 Terry

    T1 Terry Active Member

    Joined:
    Jan 4, 2015
    819
    425
    0
    Vehicle:
    2006 Prius
    Model:
    Plug-in Advanced
    I just fitted 10 NGK Iridium plugs in my V10 6.8 ltr motorhome, and I can assure you, they were not lubricated from the factory ..... in fact, I don't think I've ever seen a pre lubricated spark plug, and I have fitted thousands, I had a dyno tune business for 12 yrs, 10 to 12 car a day through the dyno, 6 days a week, 4, 6, 8 cyl ..... that's a lot of spark plugs .....

    T1 Terry