2008 Prius - Rubber piece on hatch lid

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Iamjo20, Jun 6, 2016.

Tags:
  1. Iamjo20

    Iamjo20 Member

    Joined:
    Nov 12, 2007
    259
    54
    0
    Location:
    Florida
    Vehicle:
    2008 Prius
    Model:
    Five
    This part was nice recalled, and replaced, as it got VERY gummy ! This is the little rubber piece, on the hatch lid, that you press onto when you raise the hatch.
    It "appears" to be affixed to the hatch by two phillips head screws.
    Does anyone know for where to order a replacement ?

    Thanks!

    Jo
     
    #1 Iamjo20, Jun 6, 2016
  2. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,748
    8,554
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    You would need to order the entire part from Toyota, including the switch to open the hatch. That's about $70 online a year ago.

    Or you can cut a piece of rubber (like a bike innertube) and replace the melted rubber
     
    #2 JC91006, Jun 6, 2016
  3. hchu1

    hchu1 Active Member

    Joined:
    Sep 28, 2006
    316
    128
    0
    Location:
    Houston, Tx.
    Vehicle:
    2014 Prius v wagon
    Model:
    Two
    You could also go to Home Depot, or the like, in the plumbing section is a plastic vapor barrier for placement behind concrete backer board in wet areas. It is pretty thick, thicker than bike inner tube, but still pliable. They often have end pieces and scraps that you can get for nothing if asked.

    I drilled out the holes for the screws and used silicon sealant around the inner perimeter of the rubber. That's the easy part, the nasty part is cleaning off the old black tar like stuff. Good luck. :)


    2006 Prius
    2014 Prius v
     
    #3 hchu1, Jun 6, 2016
(You must log in or sign up to post here.)