How to install rear parking camera and connect phone Prius III

Discussion in 'Gen 3 Prius Audio and Electronics' started by Haris, Sep 5, 2018.

  1. Haris

    Haris New Member

    Joined:
    Sep 4, 2018
    2
    0
    0
    Location:
    Netherland
    Vehicle:
    2010 Prius
    Model:
    III
    Hi all,

    This is my first time that I am going to use a forum so If I am doing something not correctly then please let me know. Thanks.

    I bought my second Prius Car and this time a 2010 model without a Car Navigation and Rear parking camera. I used to have both of the options in my previous one so I now replaced the Car Radio with a B9016 Original Radio/Stereo system. I also got the original 4 pins Rear camera. I am very happy with the radio but there are a few problems where I need some advise and help. I thought its a original one from another Toyota prius III so its must be a case of plug and play but The followings things are not working:


    1- There is a location for the REAR parking camera at the backside of the car but there are No Wires and Plugs.

    2- There is No Plug/Switch for the Phone at the back side of the Radio/Stereo system. In the previous Radio system I was using the Hands free system with the Bluetooth. Now I can connect the phone but I can only play and listen the music but I cannot use the Phone because the Microphone is not connected. I dont know the plug location.

    3- Navigation is also not working but I bought a GPS Antenna so If it is the right switch/Plug then It will work.

    For more details I am upload some Pictures and please advise/help.


    Thanks
     

    Attached Files:

    #1 Haris, Sep 5, 2018
    Last edited: Sep 5, 2018
  2. georgegui

    georgegui Junior Member

    Joined:
    Aug 28, 2018
    31
    46
    0
    Location:
    NJ
    Vehicle:
    2010 Prius
    Model:
    Four
    I'm not sure about you but i installed a android headunit which came with a reverse camera and wires. I tapped into the reverse light to trigger it to turn on the headunit and camera. I mounted and drilles holes in the factory location as well as a hole under the hatch trim (which had to be removed as well). I then sealed it up with goop and everything works as it should.
     
  3. Haris

    Haris New Member

    Joined:
    Sep 4, 2018
    2
    0
    0
    Location:
    Netherland
    Vehicle:
    2010 Prius
    Model:
    III
    Thanks Georgegui, In my case its a bit difficult because I have the original Head unit with the original 4 Pins camera and there is no Cable/plug connection. But I found a cable ( connector ) in Ukraine and I have to buy a aftermarket camera.
     
  4. Giga

    Giga Junior Member

    Joined:
    Aug 28, 2016
    1
    0
    0
    Location:
    Helsinki
    Vehicle:
    2010 Prius
    Model:
    III

    Did you find some solution?
    I have same situation =))))