2007 Prius Bricked by Techstream

I was just coming here to tell you that you're 12 volt is the problem when you have communication problems on the can bus in a car like this your text stream even though it's hacked and you're using a funny cable and all the nonsense usually will not break a car I'm not sure about the turning on the text screen before the car that doesn't seem right usually I have the car on sitting there ready or sitting there in accessory mode with all the lights on the dash I have text stream up on the cf-13 toughbook with the VCI cable plugged into the USB port and the other end that goes into the OBD2 port in my hand and then I stick that into the OBD2 port and then I look at my screen and then I click on the nonsense connect to text stream or whatever it has to detect the car and blah blah blah throw up the serial number it has to ask me if it has SKS or not and all that and so on and then that's it if tech can't connect to the can bus it's usually not a car problem it's a 12 volt battery problem if you discovered this is usually one of the first discoveries for us owners get to make or hear about if you're 12 volt is not above 12.5 in this AGM group size you're starting to lose voltage get down in the 12.2 and the 12.1 range and you are low and beyond that you might be in all those u codes or whatever they are I don't know those that well I only know the codes that come off the scanner off the MFD have no idea I have to look them up manually it's quicker for me to plug up the scanner and get the real codes I know a lot of those pretty well

 

I've not read of techstream bricking a prius before... And sounds like you got it out of being bricked, which raises the question of it ever really being bricked?

Once you have full power at 13ish volts and ideally a full charge and balance of hybrid voltage battery and reset and see if those codes return, let us know?

If they do, It points to bad plugs and wires or the boxes they plug into.

 

The thread doesn't say much about what dongle was used with Techstream.

I had a gizmo once built on a cheap J1962 connector with no plating on the pins, and it worked great for a few years, but then got to a point where just physically plugging it into the car (before even trying to send any signals!) would instantly produce a pile of comm errors. The same gizmo built on a slightly more expensive J1962 plug with gold-plated pins doesn't do that.