Spark plug emergency

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by pk123, Jun 19, 2025 at 3:43 PM.

  1. pk123

    pk123 Member

    Joined:
    Oct 21, 2019
    35
    29
    0
    Location:
    Washington
    Vehicle:
    2010 Prius
    Model:
    II
    So this is interesting. I purchased a 9/16” spark plug socket and the rubber stopper appears to have remained stuck around one of the plugs. It’s wedged in there now and I can neither get the socket back on the plug hex nor place the ignition coil. Any suggestions?

    Image of the socket below.
     

    Attached Files:

    #1 pk123, Jun 19, 2025 at 3:43 PM
  2. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    12,021
    2,125
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    Yes I use mag sockets about ten yrs now . Usually a still round dowel like from home Depot it's metal 5 16 comes to mind you stick it down and you get it in between the plug rubber and the
     
    #2 Tombukt2, Jun 19, 2025 at 3:53 PM
    pk123 likes this.
  3. pk123

    pk123 Member

    Joined:
    Oct 21, 2019
    35
    29
    0
    Location:
    Washington
    Vehicle:
    2010 Prius
    Model:
    II
    Thanks…I eventually managed to finagle it out with a metal pick. Apologies for the panicked post!
     
    #3 pk123, Jun 19, 2025 at 7:48 PM
  4. ASRDogman

    ASRDogman Senior Member

    Joined:
    May 29, 2018
    7,123
    3,721
    0
    Location:
    Florida
    Vehicle:
    2010 Prius
    Model:
    Two
    Take it back and get the magnetic none

     
    #4 ASRDogman, Jun 19, 2025 at 8:16 PM
  5. Mendel Leisk

    Mendel Leisk Senior Member

    Joined:
    Oct 17, 2010
    58,785
    40,475
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    It’s good to tape the socket to the extension too: the internal rubber grip can be tenacious enough to leave the hole socket down the hole, which typically means you’ve got to back the plug out, to rectify.

    I persevere with that style of socket, but I see a lot of mechanics use a plain socket, then fish plugs out with magnetic wand.

    I believe 14mm is the proper size, but 9/16” is close. I’m using the latter.
     

    Attached Files:

    #5 Mendel Leisk, Jun 20, 2025 at 10:16 AM
    Last edited: Jun 20, 2025 at 10:22 AM
(You must log in or sign up to post here.)