What P/N is this clip? What diagram?

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by MrPete, Jul 21, 2025 at 2:13 PM.

  1. MrPete

    MrPete Active Member

    Joined:
    Oct 26, 2011
    486
    189
    20
    Location:
    Colorado, USA
    Vehicle:
    2011 Prius
    Model:
    Two
    If it were not so aggravating, this would be an interesting puzzle

    Neither I my my dealer parts dept can find the diagram for this, let alone the clip P/N.

    The context photo is taken from between the two radiator fans (fan shroud on left, air intake on right.) looking towards passenger side of engine bay.

    Purple line is the (23mm diam) coolant hose held by these clips.It comes out of radiator(?) in the distance, goes horizontally toward camera, then (not in photo) bends straight down, then bends toward engine.

    I have used red highlighter to show the two clips at this level (one removed for photo). There is one more down below (cracked, not holding hose which wobbles a lot. Concerned about both failure and noise.)

    Ideas/pointers?
    20250721_113644~2.jpg 20250721_113203.jpg
     
  2. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    12,257
    2,162
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    Have a gajilloon of them . It's a hose guide I don't know what Toyota calls them you should have no trouble finding them on whatever parts break down you looking at they have them all over the generation 2 also. I did have some after I stripped My generation threes down pretty good before sending them off but I've no idea what Toyoda call em
     
  3. avoice217

    avoice217 Member

    Joined:
    Jul 20, 2022
    155
    18
    0
    Location:
    Texas
    Vehicle:
    2009 Prius
    Model:
    II
  4. NutzAboutBolts

    NutzAboutBolts Senior Member

    Joined:
    Mar 5, 2013
    1,627
    1,707
    0
    Location:
    Bay Area
    Vehicle:
    2012 Prius
    Model:
    Four
  5. MrPete

    MrPete Active Member

    Joined:
    Oct 26, 2011
    486
    189
    20
    Location:
    Colorado, USA
    Vehicle:
    2011 Prius
    Model:
    Two
    Definitely NOT the hose *clamp* (which goes at the end of the hose.)

    Those tie straps look interesting, but obviously not the same -- these allow popping the hose in and out...
     
    NutzAboutBolts likes this.