Center Vent Not Holding Position

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by mig1980, Aug 5, 2025 at 11:54 PM.

  1. mig1980

    mig1980 Junior Member

    Joined:
    Jul 1, 2011
    64
    1
    0
    Location:
    El Dorado Hills, CA
    Vehicle:
    2014 Prius
    Model:
    N/A
    Good day everyone. Today noticed that the center dash vent (on the driver's side) is no longer holding position. If I adjusted it to the middle, it just flaps up. I can get it to stay (sort of) but with road vibrations, it again flaps up. Images below.

    Is there a fix for this?

    20250805_191023.jpg

    20250805_190545.jpg
     
    #1 mig1980, Aug 5, 2025 at 11:54 PM
  2. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    12,364
    2,192
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    It's called goop in a tube strategically placed a few dots will hold vent wer you aim and put dots of the stuff not heavy you shouldn't see it wen done . Get it right once it stuck you have to break seal and roll up to get it to glop around again . Or junkyard .
     
    #2 Tombukt2, Aug 6, 2025 at 8:51 AM
  3. ChapmanF

    ChapmanF Senior Member

    Joined:
    Mar 30, 2008
    26,741
    17,528
    0
    Location:
    Indiana, USA
    Vehicle:
    2010 Prius
    Model:
    IV
    When my gen 1 was doing that I waited till I had the center dash out for another reason, and I cut a couple slivers off a thin rubber sheet and stuck them in the grooves where the vanes pivoted. It worked nicely.
     
    #3 ChapmanF, Aug 6, 2025 at 9:37 AM
(You must log in or sign up to post here.)