2006 Prius approaching 142k mileage. Any recommendations on maintenance or prolonging its life? No known issues as of right now. Below is summary of my ownership. If it’s not listed, it’s probably original to vehicle (excluding oil and filters). 2021 Spark plugs, PCV valve, coolants, trans fluid, clean Hybrid battery fan, brake pads and rotors 2022 OEM hybrid battery 2023 12V battery, front headlight bulb 2024 Tires, inverter coolant pump, front wheel bearings
Change brake fluid? Check the mechanical water pump belt. Not sure how it is in Iowa, but if that was the original belt in S. California it would likely have a bunch of small cracks from the heat. Inspect the hoses in the engine bay. Check the spare, the pressure is likely low. Unclear to me if donuts ever go bad, they don't see any sunlight and are protected to some extent from ozone, but they do get baked when the car is parked in the sun. That said, the bottom of the trunk area with a metal interface to the shade under the car should be significantly cooler than the cabin of the car under the same conditions. Probably for similar reasons I have measured the 12V battery at about 10F cooler than the cabin. Check every bulb on the car. (Possibly avoiding a ticket for having the rear license plate not lit?) Easiest to do on a lift, but the components on the bottom of the car should be inspected from time to time. Failing that, at least bounce each corner to verify that the shocks are still functioning and there are no unexpected sounds when the suspension components are moving.
Is it too late to change the brake fluid? I don’t want any risks of the expensive brake actuator replacement.
That is the debate. I had mine done recently, but it was a bit of a special case. There is a problem on my car with the front driver's side wheel running slightly warm, and when I had the "this is the guy you go to when nobody else can figure it out" mechanic trying to diagnose that problem I had him change the fluid at the same time, since he was going to relube the brake pins to see if that resolved it. He had the right tools to fix the problem if the brake actuator detected an issue from the fluid change and had a hissy fit, and I didn't. As it turned out he couldn't find the source of the heat either, and it remains to be seen if the fluid change will cause the actuator to fail prematurely. (One possible explanation is that the actuator is already failing and is causing that brake to drag ever so slightly, although not even enough to cause uneven wear between the pads on the two sides. The more likely one is that the bearing that was replaced there wasn't very good.)
