Separate names with a comma.
From what I can tell the assemblies on the Gen3 look like they have been wind tunnel tested for exceptional aerodynamics. That probably added to...
I finally had to replace my front wiper inserts after 5 1/2 months and almost 18,000 miles. Unlike some people, I do use my front wipers a lot (at...
Make sure you wait 30 days for the respray to cure before applying the clear bra. Also, you probably are already aware of this-- clear bras...
Good luck Justin. MB860 ?
Same here, as I am not convinced that these new lower ash synthetic oils with starting TBNs around 7-8 will last the full 10k and still keep...
The filters do not offer very fine filtration anyway so I doubt there is much benefit to a new filter. Modern engines for not produce much gunk at...
Usually when those codes come on you can try a stroke sensor calibration via tech stream first to see if it resolves the problem. The procedure is...
I have been doing mine every 15,000 miles so far.
Shell or Chevron. Any link to where you obtained the info regarding the Ethanol content?
The mobile guy who does paint recon work for Maita could probably refinish your hood for $200-300. MB860 ?
F8L, glad to be able to meet you and the others today. Thanks for putting the event together. Guys, I did not kill F8L during the test drive. ;)...
Wholesale Mangoose toyota diagnosing and reprogramming interface This is the one I ordered. It says it supports J2534 so I think TPMS and K-Line...
There's some hardware on the cable...it is more than just a piece of wire. I'm sure someone here can explain... I'll send you a PM.
LMAO! MB860 ?
One of the dealers I've been to, said they can warranty the mats if they wear through completely.
I am down to about 41 for this month due to mostly 10-12 mi commutes in 40F temps. I usually avg about 44 overall.
Computer, but computer is always 5% off. So I was still at over 28 mpg.
Luscious Garage | Blog | Best tires for Gen 2 Prius, continued…
Great, Davis works for me. Thanks for putting this together. I am headed out the door for an alignment to get ready for tomorrow. ...
There should not be an issue with 5/30 because there is a statement in the manual that says it is OK to use higher viscosity oils under certain...
