Separate names with a comma.
Prius is fixed and now back to some serious business. Drone racing/freestyle practice, Fly/Crash/Fix/Repeat! Spoiler alert! Theres a prius in the...
I would remove the air box, x3 10mm bolts and you should have enough room to cut the 3/8 hose in half to install.
If you enjoy keeping the hard earned money you made working 40hrs a week, I suggest staying away from the stealership. Valvoline ws atf 18$, full...
I cannot say how much time exactly, cleaning method and carbon/oil build up will vary. I lost track of time during the build due to having the...
Same here, the map sensor was also covered in wet sludge. That's why I was stressing the Oil Catch Can to prevent this built up of oil being...
UPDATE! I have driven the car 1,248 miles and the rings are fully broken in. I did an oil/filter change around 500 miles. Prius had burned out...
Another thing. A bad pcv/hose will also cause a misfire @ idle due to insufficient vacuum. I usually clean mine and have never had a problem. I...
Spun bearings is the other problem these cars have, insufficient oil flow over rod and main bearings will do this. Replace all the spark plugs to...
I don't trust the dealer, they may do a half assed job if they are busy. I would want to see before and after pics of how clean.
I would give you a thousand likes for that link. The 2016 oil filter conversion looks awesome. I never have a problem removing my filter cover. My...
Yes detonation's are bad for the engine and will lead to an early head gasket failure. If your compression is off/not even with other cylinders,...
I am running the denso SC20HR11 with 0.044 gap. Your gap sounds like it's to small. Have you cleaned/flushed your fuel injectors? Mine had a lot...
I believe #20awg was the right size for me with the drill spinning, If I had done this from the start I would have saved hours with a lot less...
Shinetsu grease on weather stripping will get rid of all the door/hatch rattle. The grease helps lubricate and swell seals to new. When I replace...
Tap the filter cover with a hammer all edges. Tighten it 1/8 turn in. Then loosen it off.
If its high, horizontal leaks from Valve cover(rubber gasket), {A}camshaft housing sub assembly(grey rtv), {B}head gasket. {C}Stiffening crankcase...
It is a lot of labour. Remove wheel, remove water pump, remove pulley, remove engine mount, remove windshield cowl, remove valve cover and then...
Your engine sounds like it is done. If you ran the car low on oil you may have done irreversible damage. A clogged pcv and upper crankcase vent...
What I was talking about is whether or not the oil has enough contamination to the point it is no longer an sae 20 rating @ operating temperature....
zerex was 13$ @ advancedauto [ATTACH]
