Separate names with a comma.
Surprised you were able to catch it right at 17. Watched mine from 18-17 and as soon as it hit 17 it immediately shot up to 30+ welp, I've...
I'm on my third discharge now, and there might be some rain during the final charging. Is it "safe" to pause during this charging in order to roll...
thanks, I think I'll suck it up and do the whole thing for peace of mind.
wondering if it's worth only doing 2 cycles with my battery that has a block .02v lower than the rest. P0A80 code, displayed MPG all over the...
I'm guessing they salvage your old battery and sell as a reconditioned unit?
You can also just replace block 5 with 2 new (used) modules. Less than $100 in parts, not sure about labor. I'm pretty sure Toyota won't do it...
just did mine today as well and it's at 247 volts, after about 6 hours so I think it's probably in the balancing phase now. Their site says it can...
It's been 5-6 hours since I've started charging and my voltage just showed 247. Seems a little high but others have reported around that range....
anyone have experience with this $8 filter? [MEDIA]
Was able to see the resistance values in the dropdown. Lucky number 7 is proportionately higher. Definitely the culprit. Will update after the...
could be my cheap chinese OBD isn't picking it up, however I don't recall there being any other when I had auto zone scan it, unless theirs didn't...
it appears block 7 is the issue as it's a little low compared to the rest, so hopefully I can fix it with the prolong charging/discharging kit.
Delta SOC holds steady at 1%. here's a recording of everything while under load. first AC, then heat. [MEDIA]
what should I be looking for while under load? also here's a readout with it running: [MEDIA] should I use AC or heat as load?
no load, should I be?
is this a warmup cycle? [MEDIA]
[MEDIA] showing rapid cycle
[ATTACH] all voltages are normal, so it is safe to rule out HV as the point of failure? these values are after the car has been sitting cold,...
[ATTACH] [ATTACH] [ATTACH] all my cell voltages are right around 17 but I'm getting P0A80, and my HV drains within a minute of sitting idle....
