Separate names with a comma.
so you upgraded to a gen 4 motor if so I am about to do the same any advise or tips what tool was used to swap the flywheel Also your cam sensor...
What tool do I need to remove flywheel and fuel line ?
they could not figure it out. I double checked piston travel and found number four to go 3 millimeters lower than the rest. I suspect bent rod or...
first three yes number had higher comperssion. like 190
ON a side note this bothers me the only reason for a height difference in piston travel height is a bent rod worn bearing right as the car runs...
I FIXED THE ENGINE NO START! is was IGN #2 fuse in the engine bay. now on to replacing the engine bay diagrams on the cooling reroute to get the...
[ATTACH] [ATTACH] where would you focus? im thinking power source control. or ECM(Engine) either a fuse is blown or relay. would you happen to...
yes dome lights work and all dash lights. I cant use my generic odb Im using this tech stream seems to have more functionality. I will check fuses...
Sorry I was on my phone outside for most of this. Now aux battery is at 11.4 so battery is low needs to be replaced. so I have connected my truck...
Did you get this figured out
I started the car on its own power no jump pack that Was later only due to low battery then a truck as I lost confidence in jump pack. Nothing...
did you get this fixed?
here are the codes DTC U0293 UO100 U0101 U0151 U0164 U0293
I suspect the spark from the coils may have arced and fried the computer. I barely know how to use techstream but here is what I got, I hope you...
Hello I see you have a bit experience with tech stream. long story short. my engine has bent rod I will be replacing it its a 2010. in the...
Ok I think I know what happened with he coils out and the engine grounds loose when I started the car the coil sparked and likely arced into the...
[ATTACH]
is there a main fuse to the ECM or relay or i fried it? if so how much are they and can I DIY?
I also forgot to reconnect the engine grounds so I suspect I shorted something out.
