Separate names with a comma.
The passenger side headlight bulb is way over in the small confines of the corner, you probably removed the high beam bulb, which is a 9005. Yes,...
You should expect to lose about 5 mpg. You don't notice any lag or heaviness when accelerating from a full stop? Some have described the feeling...
Yes .
Don't know about permanent codes, but often it takes about 10 cycles of the Power button to clear the Check Hybrid System error once the error...
Suspension damage, body damage, probably frame bent, also a lot of force applied to the transaxle. I also believe it's a total loss. Posted via...
Can you elaborate on the following? "the 3rd gens i upgraded a few parts..." .
If using drain cleaner in crystal form, you need to be careful when you mix it with water. Always add the crystals to the water, not the other way...
Did mine similarly at 124k, but you won't be able to get every single channel clean that way, due to the angled inlet walls. The most effective...
The steel wool is for increasing surface area for the hot oil vapor to condense to the liquid state. As mentioned, it's normal for the OCC to...
Yeah, didn't state how many miles were driven since the 95k when EGR was first cleaned. .
^^^ Very nice fall foliage in that last picture. .
Nice work, and design. [emoji106] .
HID, and they're for right hand drive Japan market, so the cutoff is wrong. .
I agree. .
I installed the cat shield myself using jackstands at 4-corners, but I would not like to do it again. There was very little clearance to get under...
At least the kit includes LED foglights as opposed to standard reflector foglights with halogen bulbs. Those are the ones that are pretty much...
Check out this thread: LED Headlight Conversion | PriusChat You have to get/make a harness to connect the LED headlights to your non-level five....
Well, if this is the pads you purchased: Hawk Performance HB596F.690 HPS High Performance Street Brake Pad [MEDIA] There is a review from...
Do you mean that you pushed the caliper cylinder back all the way and the caliper holder with pads installed don't fit over the rotors? Posted...
I had a distinct rattling after doing major maintenance on our 2011. Turned out to be a bolt that I forgot to tighten down. It was specifically...
