Separate names with a comma.
Just because it says Denso on the box doesn't mean it is a genuine Denso product. eCommerce sites are full of fake name-branded look-a-likes....
You won't find one because there is not a single configuration. It is not really rocket science as I hope my further responses below will...
If you want to know with 100% certainty, the part number is on the back of your current MFD. Get a replacement unit with that part number and you...
Have it tested and if it fails testing then replace it. If it tests fine, leave it be but monitor it regularly.
It actually will not run on electric only unless the hybrid vehicle (HV) battery is very full. You have to remember that a Prius is not an EV, it...
+1 to cleaning the MAF and also cleaning the throttle plate and throttle body won't go amiss. I would strongly advise against using a Q-tip or...
Don't you think you will get better advice and help by posting a proper informative thread in one of the Gen 3 forums seeing as the car in...
Sure is. ;):D Popular color, that green mica
That doesn't make sense. If you have a trouble light for the ABS showing on the dash there will a one or more codes in the ABS/TRAC/VSC section...
... that lasts for around 50 seconds then the engine shuts off. This assumes you don't drive off in the meantime.
Find a replacement unit at a pick and pull and swap it. Get the part number off the back of your existing unit and get a replacement unit with...
Maybe ask your question in the Gen 4 forums. Any information pertinent to Gen 2 is not likely useful in the Gen 4 setting.
Here's a picture of the connector (ignore the instructions, that does not necessarily apply to your situation): [ATTACH]
For the Gen 2, the Haynes manual is incorrect. The pump should always be operating when the car is either IG-ON or READY. If the pump runs when...
The problem is that there is not enough potential difference between each module to effectively move enough electrons around so it is largely a...
Is that both with the A/C Auto control on the MFD and the steering wheel buttons?
Almost, at least for the Gen 2. The meter is calibrated so that "full" is 80% and "empty" is 40% +/- a couple of percent at either end.
With what did you scan the codes? There are nine INF codes associated with the C1377 code (101 102 103 105 106 108 109 110 113) so knowing them...
I'd forget about step 4 (and step 6, if that means repeating step 4). This 'equalization' process doesn't do anything useful, so save your time...
Note that that procedure contains an error in both the removal step 3 and install step 2. The parts labeling is transposed in each case. The...
