Separate names with a comma.
My idea at this point is that the ICE must be completely removed to replace the damper anyway. Since I can pick up a junkyard engine locally from...
Coolant I think is good. I'm betting there's an EGR issue and that caused a miss which caused the broken plate springs. I found pieces of the...
It's clanking quite a bit when HV battery is being charged. This Gen 3 has 180K so I'm guessing HV might be questionable anyway. I'm thinking of...
Yes, that would bring the clattering to a stop. I'm guessing the driver didn't see it as a comprehensive solution though.
ooops!
I did replace plugs and coil packs although not sure those were really problematic. There was a code for the water pump and I'm thinking an...
I saw some in the 300 range (I think aftermarket) and saw some dealer parts in the 1,000 range. Obviously, I'm not doing the dealer thing,...
Yes, and I think it probably had codes for awhile because this particular owner just likes to sort of run the thing until it's painful to listen...
The Gen 3 is also spraying oil all over the car when it runs...especially at the back. I'm wondering whether that could be a stuck ring (maybe...
I couldn't get fingers in the inspection plate to retrieve spring pieces but a small magnet on a flexible stick was able to pull a number of...
Well, the original engine did implode. Now, the car has a junkyard replacement engine.
Thanks. I'm going to get my fingers into the access and see if I can find those spring fragments. The guy who owns this Gen 3 will drive the...
Would an EGR issue set a code? If it would, then I'm thinking transmission damper (or whatever it's called) because I assume that would not set a...
P261B, P0300, 0301, 0302, 0303, and P3190 codes have gone away at this point. However, annoying noise persists....
I don't have P0401 for reduced EGR flow. I'm wondering whether the misfire could be from overheating (water pump or blockage?) causing misfires...
I doubt EGR has been cleared or checked so that's a good place to start. Mileage is 185K, although ICE is from a junkyard and I think it's around...
The codes listed above have appeared around the time of an overheat condition, although I don't see head gasket symptoms at this point. The owner...
I would install myself because I think I'm more likely to do it correctly (although I'm not formally trained) unless it was a warranty question...
