Separate names with a comma.
I decided to drop the sensor into the hole in the sheet metal. Gravity might keep it there. I could find no way to lock it into place.
I spent 2 weeks reconditioning my traction battery. The triangle light was on and "Check Hybrid system" message was on. I cycled discharge/charge...
I removed the temp sensors to recondition the battery modules. I cannot remember where one of the 4 sensors goes. It is the one closest to the...
I have been using a CQ3 charger to recondition/test my modules. I learned that, according to Battery University,that a fully charged NiMH battery...
I read on Battery Universe that a NiMH battery will self discharge 20% in the first 24 hours after charging. That seems high. But, play it safe....
I have CQ3 chargers. I was getting some strange results in the recorded data. The charge and discharge readings would go up, way down and up again...
Trying to load Techstream I bought Windows XP 32 bit on a CD to load on my old laptop. It currently has 64 bit Win 10. I was unable to load the...
I just bought a booster pump from Toyota and then saw a seller on ebay who sells a new one for $399, which is much less than I paid. It has a one...
I did think of a reason that it will stop discharging. If the voltage drops down to 6.2 volts (where I programmed it), that would end the cycle or...
I set it up and ran it overnight. One of the channels read "END" after charging. The discharge and charge numbers were 3707mah and 5090 mah. I set...
I am waiting to receive a 32 bit version of Windows so I can bleed my brakes correctly. In the meantime, I want to remove the traction battery to...
I just began charging my traction with a Bguad 4 channel charger. My question is, how can I run the battery cooling fan while charging the...
I spent days cleaning my EGR cooler and intake manifold. They are clean. I still get P0401 (along with other codes). When cleaning, I removed the...
Since I just replaced the master cylinder and the pump, there is air in the system. After my battery came up to 12.5 volts, I turned on the car,...
I just found that the 12 volt battry was very low. Weird things were happening with dashboard lights and cheap OBS2 tester. Charging now with slow...
I just replaced the brake pump and master cylinder. I viewed youtubes on bleeding brakes without Techstream. The first step is to put car in...
I looked for a post for adjusting the switch but did not understand the procedure. [ATTACH] First, remove the black plastic panel under the...
The part that I removed was stamped 47070-47050. The part that I bought and installed is the same part number. The dealer insisted that if the...
The master cylinder was easier to install. I made one mistake; there is a bracket that supports the red brake line next to the M/S. The bracket is...
