Separate names with a comma.
Mr. F thanks again for your excellent advice. My resistance reading was lower than the specs you quoted. All the wiring looked solid. I finally...
Thanks Mr. F. Very helpful. May I ask where I can find online a copy of the repair manual you mentioned?
Been getting an error telling me there’s a problem with the brake fluid reservoir. I assume it’s the sensor. Chat GPT informs me it isn’t just a...
Thanks. I disconnected the battery for 10 minutes or so. Took the dongle out. Reconnected the battery and started the car. The dash lights remain...
I was going to post on erubin2000’s post below about his ABS question but decided it would be better not to. I replaced my ABS actuator on my...
FYI Okay, I manned up and dove back under the dash to try again. It turns out (1) that brown nut does NOT turn. Don’t try. (2) one only has to...
Realize this is an old posting but I would like to know how to remove that brake light switch. I have access to it from under the dash. Being...
It caused communication problems when installed that were not clearable using Techstream. Plugged in original and communication issue went away....
Thank you. It’s a weird one for sure. Wish I had noticed before I installed it.
TLDR. Anyone know if this is off an earlier generation Prius or even off a Prius at all? Purchased off eBay from a seller with JDM engines in...
Your description was fine. Thanks again
Found it, thanks for taking the time to help. Not sure why I would have taken that hose off to remove the brake actuator but all’s well. Here’s...
Excuse my confusion please. Are you talking about the circled tube?[ATTACH] I should have highlighted it in the original question instead of...
2010 model. Putting in a used brake master cylinder. The tube in question is the vertical black tube with a gray inside that’s just beside the...
Thank you.
I’m finding conflicting information concerning this. My actuators model number is 47270-47030 and I purchased an early 2010 model. Early models...
FYI The “check hybrid system” was caused by the used brake actuator I installed. A communication issue that can’t be cleared by tech stream....
It’s a used actuator from JDM motors. Because from who I got it I figured it would work. We’ll see. Lol I did forget to push the orange handle....
