Separate names with a comma.
thanks for the response. I have an Innova 5610. I didnt use a grid charger but the tool readings show a consistent voltage across all the...
I ended up pulling the hybrid battery out and replacing 8 cells that I got from Ebay, cleaned all the terminals and copper connectors...
Yeah i seen the video on youtube where the guy heats up the headlight in the oven. I tried using my heat gun but it was stressing me out because i...
I like those too. I thought about just buying them but Im was trying to avoid putting too much money into this restoration, theres still other...
Finally I cleaned the area with rubbing alcohol and used some aluminum duct tape to seal up the hole to keep out any dust and moisture. Installed...
After installing the bolt i snugged up the first nut just tight enough that the first outer most washer can still move with your finger tips, that...
Next i purchased a pair of 1/4" x 2-1/2" bolts, four 1/4" hex nuts, two fender washers with 1/4" hole, two regular washers with 1/4" hole and a...
Then i drilled out the adjuster screw hole with a 1/4" drill bit and de-burred it by hand with a larger drill bit.[ATTACH] [ATTACH]
Then I pried off the locking washer on the inside with a mini pry-bar tool and removed the adjustment screw with a pair of vice grips. This part...
So first i used a large hole-saw (2 5/16" is what i had available) to cut an access hole to the up/down adjuster, It has to be large enough so you...
These are the style headlights. They have that bluish color to them.
Im sure plenty of people have had this issue with aftermarket headlight assemblies. You go to try and adjust your headlights because theyre...
"MFD Touchscreen assembly testing and repair?" I posted this thread earlier. This is the first problem I'm trying to sort out. Then there's a few...
Im presently trying to test mine. I only connected pins 2 & 3 to 12v+ and grounded the case. All it did was illuminate the toyota logo briefly and...
