Separate names with a comma.
Hey all! I know that this is an old thread, but i was hoping to be sure I understand.... an NHW10 (dec. 1997-2000ish) had the cylindrical cells...
SOLVED!!!!!!!!!!!!!!!!!! The LONGEST this car went without a check engine light was 1 second - thats right, clear the codes and CEL back on in...
so I got 13.4 on the 20k ohm setting and 13.9volts on the harness going to the ECU... are those numbers normal? I jsut dont see how the theft...
Thank you! the sensors test fine sadly. If I clear the codes and start the car I get p0037 which is b1s2 low thanks :)
Sadly not the case. I can visibly see the harness - it’s on the side of the exhaust tunnel inside the car under the right side dash. It was not...
Ok so I tried a brand new sensor as a control. Didn’t install it in the exhaust, just plugged it in to see. Sadly the engine light comes...
Thank you both very much for the reply. The biggest thing I am grateful for here is that if I do need to swap the ECU, I don’t have to worry about...
Hello, After replacing a stolen catalytic converter, I am immediately getting P0038. I tried a couple different used oxygen sensors that were...
Hey! I understand that I am replying to a 19 year old thread, but back to the cylindrical cells found in "gen 0" 1998-2000 Prii. I am an importer...
Hey all, I am about to pull the trigger on a gen 0. For Those who don’t know, the 97, 98, 99 and possibly 2000 prius was different then our gen...
my initial though (which I worked funny above) was to use basically a gen 2 or gen 1 (if i can find it) chassis and cells with custom bus...
I hope so! Here is one up for auction in Japan in a few days. Rougher than i'd buy but just an example [ATTACH] [ATTACH] [ATTACH]...
Hey thanks! So in your second to last paragraph were you speaking of just gen1 or comparing it to gen 0? I’ll keep this info handy! Not many gen...
