Separate names with a comma.
Hello Critic, I am also looking for a trailer hitch for my Gen-3 2010 Prius. It seems like most of the ones out there stick out just enough to...
What I was told by the dealer is that they would take the OE hot-teflon wheels off my car, send them out to have them chromed and then put them on...
Embarrassingly, I probably paid too much. Bought the car new and swapped the original hot-teflon wheels for the chrome. They are OEM in that...
I agree with PearlJammer, wheels do make the car. I like his, but I like mine better :) PriusChat Forums - bricor's Album: my 2010 prius v
001 Dremel 114-199 cutting bit
005 I did a lot of research and this is the best consumer product I could find
008 Not sure if I am going to use this. I will probably let it go for a while to see how this new application holds up first
006 This is what it will look like after you place the fender washer on - LET IT SET FOR 24 HOURS
006 If you can't find a fender washer with a 1/4 inch hole, you may have to drill it out like I did
002 Using the Dremel tool, cut out and recess the bolt holes
003 Be sure to roughen all surfaces (I used a bench grinder)
004 Mix and fill the hole first, then place the bolt (this pic is pre-mixing epoxy)
To All, I have been through this too. The 1st time I used JB Weld Kwik (epoxy). It held for a few months then came loose. I'm now in the process...
The V+atp is good for people like me who are geographically challenged. I can't tell you how many times the nav system has bailed me out from...
I just posted mine (black) in the 'photos' section 2 days ago. Check em' out! Is there a way to move them to another location? bricor
