Separate names with a comma.
Hi there - when you installed the tilt sensor did you use the 2x relays? I've found some folks that have only used 1x relay - doesn't seem right.
great stuff. I am using 16 gauge wiring. did notice it was only going down to 6.2/6.3. Makes sense. Always thought that going all the way...
Hi All, So i read the sticky here and wanted to go over a few things. I've also watched a ton of the youtube videos and read through a lot of...
It’s directly related to engine rpm. Will happen when car starts this morning in the very cold. Then go away. Happens intermittently while...
Just started a few days ago. Especially now that it's well below freezing in Denver. At around 2000 to 2300 rpms there's this whirring noise...
I do this drive 3x times a week - i've perfected getting optimal regen so the engine doesn't go into high rev mode. once you get to 75% SOC or...
A couple of PID questions for you. I'm using the software that comes with my OBDMx I monitor my coolant temp while i'm driving and I live in CO,...
I've been digging around the site, but the closest I can find, which doesn't directly do what i'm looking for is the BMS device, which is long...
yes! was one that I knew was most likely bad. I just changed from 5A to 2A and then set my delta peak to 20mV instead of auto. The 5A spooked...
So I'm using a hobby charger to refurb a used set of cells. I've got a CQ3. 7200mah capacity, 5A charge, 1A discharge, 6v discharge votlage. I...
