Separate names with a comma.
When I did mine - I just covered the hole losely, then put extra pressure on the door panel with the foam still on there, the deadning material...
DrDiesel - The volt is not sold at a loss on a per unit basis. Its only sold at a loss if you factor in R&D costs divided by units sold - this is...
Yeah - I think we are on the same page - I was just a little behind and that was in response to DrDiesel - I just forgot to quote in the response.
That would be a tax deduction man, this is a credit - definition of a credit is a direct reduction in the amount of taxes owed, not to exceed the...
I paid $13450 in Federal Taxes last year - I can assure you - I am eligible for the full $7500. :) I know it does not work for everyone - I am...
Yes Negative Equity sucks - but as I mentioned above - Cost is a non-issue. I chose the C for looks when I traded in the 2 year old Gen3. I Paid...
Hahaha - lots of assumptions and speculation here regarding operating costs. Sorry I wasnt around this weekend to get in on all this fun. Here...
In 2010 I leased a Gen III Prius, after two years I was at 50,000 miles on my 45,000 mile lease with 1 year to go. I talked to the Dealership...
Comprehensive write up so far - looking forward to seeing the rest of the car. The biggest difference was when the entire vehicle was complete...
Having had my headliner out to install sound deadener - I can confirm that there are two thick structral beams running down the roof. I have...
LOL - Your not missing much with entune except for a headache. I will trade you my entune system for that kit any day.
I would reccomend doing the floor - that removed as much road noise as doing the roof did. There is really not a ton of additional hardware,...
10 Sq feet per door if you want to do the outer skin and inner skin, if you are just doing one of the door skins, you can probably do fine with a...
I put in over 100 pounds of sound deadener, and 50 pounds of additional audio equiptment - no MPG hit at all, I can still pull 60's and 70's on...
