Recent Content by EdwardFlorida

  1. EdwardFlorida
    Post

    2008 Brake and ABS light on and off

    Fluid level OK I will try to get codes. May go a several mile normal then come on. Stays on maybe 30 second then goes off again
    Post by: EdwardFlorida, Sep 6, 2020 in forum: Gen 2 Prius Care, Maintenance and Troubleshooting
  2. EdwardFlorida
    Post

    2008 Brake and ABS light on and off

    also if I pump the brake a couple of times the lights go off and brakes are normal again
    Post by: EdwardFlorida, Sep 2, 2020 in forum: Gen 2 Prius Care, Maintenance and Troubleshooting
  3. EdwardFlorida
    Thread

    2008 Brake and ABS light on and off

    2008 prius ABS and brake light come on and off. When off Brake function is normal, when on Brake performance poor as if no power assist.
    Thread by: EdwardFlorida, Sep 1, 2020, 4 replies, in forum: Gen 2 Prius Care, Maintenance and Troubleshooting
  4. EdwardFlorida
    Post

    Red Triangle

    Finally got it to go to ready by unplugging the hybrid battery plug on the drivers side and leaving out for 15 min. Now to go get a thorough...
    Post by: EdwardFlorida, Jul 21, 2020 in forum: Gen 2 Prius Technical Discussion
  5. EdwardFlorida
    Post

    Red Triangle

    Also when on the hybrid Battery indicator has 6 blue bars
    Post by: EdwardFlorida, Jul 20, 2020 in forum: Gen 2 Prius Technical Discussion
  6. EdwardFlorida
    Post

    Red Triangle

    Get 12. 1v at fuse panel
    Post by: EdwardFlorida, Jul 20, 2020 in forum: Gen 2 Prius Technical Discussion
  7. EdwardFlorida
    Post

    Red Triangle

    Dash is not black. All lights, brake Check engine Red Triangle etc. are on.Disconnected 12v for a while no change Replaced AM2 Fuse Not sure...
    Post by: EdwardFlorida, Jul 20, 2020 in forum: Gen 2 Prius Technical Discussion
  8. EdwardFlorida
    Post

    Red Triangle

    did bleed inverter
    Post by: EdwardFlorida, Jul 19, 2020 in forum: Gen 2 Prius Technical Discussion
  9. EdwardFlorida
    Post

    Red Triangle

    from Display monitor on dash 12v battery now says 11.6v
    Post by: EdwardFlorida, Jul 19, 2020 in forum: Gen 2 Prius Technical Discussion
  10. EdwardFlorida
    Post

    Red Triangle

    12.2 v on the 12v have not bled the inverter yet. Do not know on the OBD2 it is an Autel 309 Can you recommend a good hybrid compatible reader?
    Post by: EdwardFlorida, Jul 19, 2020 in forum: Gen 2 Prius Technical Discussion
  11. EdwardFlorida
    Thread

    Red Triangle

    Had inverter water pump go out again blows fuse dash goes black. Car dead in water. Replaced pump see flow in tank. Disconnected 12v neg. Still...
    Thread by: EdwardFlorida, Jul 18, 2020, 11 replies, in forum: Gen 2 Prius Technical Discussion
  12. EdwardFlorida
    Post

    Can't go into ready.

    Energy monitor problem solved 12v battery ground tightened.
    Post by: EdwardFlorida, May 13, 2019 in forum: Gen 2 Prius Care, Maintenance and Troubleshooting
  13. EdwardFlorida
    Post

    Can't go into ready.

    Did the first test here once codes were cleared. Went to IGN-ON and the triangle and other lights came up after about thirty seconds. It did...
    Post by: EdwardFlorida, May 8, 2019 in forum: Gen 2 Prius Care, Maintenance and Troubleshooting