Separate names with a comma.
So just an update. Changed the master cylinder for new. Bleeding procedure and linear valve offset learning completed without a hitch and a lot...
Three solid lights, slippery road, BRAKE, and the one that looks like a tire with clamping brake shoes around it. During the learning process...
The freaking names change across the different models. We changed the lower thing pump and the nitrogen filled canister. I'm pretty sure the...
Iirc the brake, traction control, and slip warning lights go solid on when the pump fails. Plus the brakes revert to old school hydraulic and the...
Tried the learning again. Just like before it didn't take. The instructions say that the lights should stop flashing and when completed flash...
2 actuator accumulators where changed. First one was from eBay and the second one from Olathe Toyota. The lineir valve offset didn't take with...
I made is smaller and good thing because the blue one wouldn't fit. My brother used it yesterday. He spun the knob holding the nut with a long...
I helped my brother change his actuator accumulator a few weeks ago. The PDF from Toyota shows an unobtanium nut spinner. We got it started with a...
thanks! perhaps come springtime and I'll take that sintered filter out. I cleaned the egr cooler for my brothers gen3 and would rather not need to...
It's not the fine cone type. It is flat and coarser than the one I found a pic of here: Oil Catch Can, Eliminate that knock! | Page 33 | PriusChat...
Why yes it is! The nut of the filter holds a little deflecter for the inlets. I guess I have to get rid of the little brass seeds and put it back...
2014 level 5 with 56000 miles I wanted to install a catch can before anything clogged in the egr cooler or anything else. Read a bunch here. I...
Okay, I want to print a larger bigger tuning knob for my 2014 Prius Level 5 (not V) Nav, lane assist, etc. I can't get the existing knobs off to...
