Separate names with a comma.
Procedures A and B worked for my 2007 Prius with a non-Toyota key fob purchased from e-bay: For 2004 2005 2006 2007 2008 2009 Toyota Prius Smart...
In case anybody cares how the story ended... I charged my battery for a total of about 20 hours. At that point in time, I was able to measure...
I will also add that my car insurance is through Metromile (now Lemonade), which means that I have one of those sensors stuck in my OBD2 port that...
I'm pressing the leads of my voltmeter directly on the battery posts. I used the same method to successfully measure the voltage on my wife's...
Another update that might be important... Yesterday, even though I had already tried to charge the battery once, and the charger told me that it...
I'm realizing that this means that some of my prior messages were unfortunately misleading. Anywhere where I've said I measured "0 V" or "no...
That's a good question. I wondered the same thing. However, when I try to measure the voltage across the battery terminals during or right after...
Any other suggestions for what I should check before I take the battery back to the Toyota dealer?
Thanks for weighing in, guys! Fortunately, my wife has a Prius with a working "12V" battery, which allows me to take comparative measurements....
Hello folks, Last weekend, I tried to use my Prius after it sat idle for a month and a half. However, I found that the car was utterly...
So I obtained a copy of the "Haynes Repair Manual" from my local library, but it says basically nothing about how to bleed the brake hydraulic...
Confirmed: DTC C1343 has returned. As before, it seems that the presence of DTC C1343 prevents solenoid SLARR from activating, because I can't...
Thanks for weighing in, mr_guy_mann! Your suggestion is timely, because, just yesterday, I drove my prius around the block, periodically...
An unexpected plot twist... Reading the repair manual, I came across the following: "The voltage between the terminals of the brake actuator...
