Separate names with a comma.
Spoke too soon. Misfire still. I'll test the resistance next chance I get to confirm that it's not just a bad spark. I swapped the order of the...
400k km. Replaced all 4 plugs. Misfires all stopped. Still throaty and EGR desperately needs cleaning. Just don't know how to do that yet.
Got a set of NGK laser iridium from CT. Noting that they came with the cardboard sleeves. Production batch stamps of U399 and U2XM. At least for...
Similar issue. P0301, P0302. Shuddering at idle. Pulled the sparks. What do you think? I could swap them around and see if the misfire moves,...
1) Did you replace the HV battery pack? No. Do you maintain it? No 2) Did you replace the 12v battery? No 3) Did you replace the transaxle...
Sorry to revive an old thread, but I think a few years down the road gives some changes to consider. In any case, here's my situation. I have a...
Not sure if this is helpful, but I've found a quick test for bearings was to kick the tires. A healthy bearing will give a rubbery hollow sound,...
FYI, if anyone wants to DIY a front bearing assembly. I highly recommend getting an air hammer instead of the slide hammer. Use the air hammer in...
I have a 2012 touring. The right bulb went out. I can figure as much that it's a combination purpose for daytime running light and hi-beam. Popped...
My 2009 got rear-ended hard enough to crush in the rear-right wheel well enough to impede the tire from rotating. Trunk compartment took a...
Does anyone know if the 4 mounting holes which secure the hub to the knuckle have threading on the knuckle side of the holes, or is the threading...
Maybe, but I'm not sure what to attach it to, aside from just using it to vibrate the heck out of the hub. (Correct me if I'm misusing any...
Not so much. The threaded rod approach requires that bit of wheel which the rotor mounts to to still be attached to provide something for the rod...
I had a slightly different experience with the front left hub. The slide hammer didn't so much fail as the bearing did. So the bearing came apart...
