Separate names with a comma.
Found where I saw the parking brake thing: http://myvenza.ru/tech/pdf/Brake_Fluid_Replacement.pdf Air bleeding with the Techstream cannot be...
The only line that air could've been introduced into is this front left line. Which relays do I pull for manual bleeding and do I still put the...
It asked me to remove both ABS motor relays which I am assuming is "ABS MTR" and "ABS MTR 2". It tells me to put it in ON/IGN mode which I assume...
Techstream does tell me to remove the relays but I will try again, without doing so, tomorrow. Yes, everything else shows up properly and seems...
Yes brake lights work and parking brake light works. But neither the brakes or parking brake trigger the brake value in the MFD
Unfortunately, I do not have a second person to help me hold the breaks while I open and close the bleeder screw. I tried to do it by myself but...
but why is the procedure failing in techstream
Ok, so I have taken the caliper off and verified there is basically no return. I have rebuilt the caliper and now it is much hard to push the...
Quick update, haven't had time to do the flush. I am, however, going to start with that. As for measuring the return on a bench, how do I do that...
Based on the glazing on the pads, I'm rather sure the wear ridge is not what is causing the friction. The fluid in the reservoir is actually kind...
Those are indeed the new pads and there is a small lip on the outer edge of the rotors but it's small and should be outside of contact area (hence...
You misunderstand, it's the 12v accessory battery that is bad. My traction battery is perfectly fine still, thank god.
I'm going to do the full flush this weekend. I'm going to try that first as I'm very nervous about pulling the piston completely out. I have never...
If you are trying to test the maximun amperage of the batterry cell, you should either use a digital battery tester that tests internal resistance...
I don't have any service manual, and as for the bleeding, I was doing what post #2 was asking for diagnostic. I had a hose filled with brake fluid...
