Separate names with a comma.
I can send power to my fuel pump with my Autel scanner. I can hear the integration relay clinking. I am still not getting a reading at the fuel...
I get a millivolt reading when trying to power the ICE at the fuel tank connector
Car goes to ready mode. Tries to start for the 6 seconds then red triangle and Poaof,P3190
I hooked up a jumper pack to the 12V battery and that did not solve the issue
Trying to start the car with a jumper pack connected directly to the 12v battery did not fix the issue.
I detailed my Prius for about 6 hours doors were open and then this problem came up. 12.16V 346 CCA interstate MTX-S46B24R
2008 Prius with these codes. I have a correct reading of ohms .7 and with 12v applied to pump connector under rear seat my fuel pressure is 48PSI....
New issue with the Prius. I have codes P3190 , P0A0F. My oil level is corrected it was a 1/4 inch over full line. I have a full tank of gas....
I installed a different rebuilt battery and the red triangle is gone. I did notice my first replacement battery had a red label ecu and the new...
Yes I was wondering what those wires did. I have seen a video where the red wire connection was broke and the hybrid fan would not spin without...
Tomorrow I will inspect the wiring going to the battery ecu. I opted for a reconditioned pack so I got the whole unit. I am in contact with the...
The wire connector that is located next to the hybrid fan. What is that connector for? I did solder those connection but I almost feel there was...
Inhaling air temp -86.8 °F battery temperatures are reading at 71.6, 72.14, 70.16
I do not have the codes from before I replaced the hybrid battery. The three codes listed are still present. Having the door of the car open when...
