Separate names with a comma.
The key was to install the seal flush with the surface of the tranny. The outside of the seal is flush and the inner "cone" part actually sticks...
Actually I think I found the problem. It seems I may have been pushing the seal in too far. I thought it needed to be pushed in tight but instead...
2005 258,000 miles all good
Ok here is a pic of the tranny where the seal goes. It looks like an oil passage on the bottom with a matching one across for it on the top. This...
Sorry. I should have added more info. Car is 2005 with about 258,000 miles. I replaced the right side shaft because the boot tore. It was leaking...
OK I've replaced the seal 3 times now and it keeps leaking!!! What am I doing wrong? Seals are about $14 each so this is getting pricey. I made...
OK cluck is gone with new axle, so you guys were right. The only problem is it is leaking. I've replaced the seal twice now and keep screwing it...
The axle I replaced had a bad boot. It seems that one has a little play in it so I pulled it out and getting another one under warranty seeing...
Well I jacked the car up and there doesn't seem to be any play in the axles. With the tires off the ground I can move the tire a little in each...
Undercarriage isn't toooo bad. It has 289,000 miles on it though.
Shafts are fine. Really think it has something to do with this bushing and where it came from.
[ATTACH] I was under my 05 prius replacing the exhaust donut on the manifold and saw this piece stuck in the cross member. I thought it may have...
Huh? Is that hard to remove it from the transaxle?
