Separate names with a comma.
Today I went to power down all the windows in the car as I was driver (alone) and I detected a lag on the non-drivers windows. I raised them and...
I wish we had a detailed schematic or an opened-up HVAC unit mixer door from this car, so I could see how the mixer door works. I bought a...
OK, so I flushed the heater core (it was clean) and placed a thermal probe on the core in the dashboard unit, while things were running. It...
I have a contact thermal temperature gauge on my multimeter I could try. Also, I wish I had the schematic of the airflow in the heater assembly...
I rant he car for at least 30 min in maintenance mode. Here is what I learned: -I did have a small leak on a front radiator hose, which explains...
Thanks Chap, this is really helping. I'll run the suggested test. I also watched engine temp and the coolant was plenty hot enough. If it is...
Oil and coolant are good. I even drained and refilled both recently to be sure. Made sure to open air bleeder on coolant refill. Coolant level had...
Well, I have a used 2010 I bought in May 2018 and only now is it cold enough (40degF) to need the heater, but I barely get any warm air...just...
Ok, so I removed the vent tube to the passenger side foot area, and I can see the actuator and two radiator-like metal blocks inside. when I crank...
OK, so I ran techstream and monitored the "Air Mix Servo Target Pulse" and "Air Mix Servo Actual Pulse". I also watched the room air temperature...
I have a no heat problem on my 2010 even though I have hot coolant circulating in/out of the core. What did you do?
Does anyone have an visuals on where the blend door assembly is on a 2010? I have no heat even though the two coolant hoses goign into the back of...
I'll try that Chap. I have a bluetooth OBDII adapter and will find an app or check with my friend who has Techstream I did completely drain...
