Separate names with a comma.
I broke the clips on a part in the trunk and I'm wondering if anyone can help me find a replacement. I've looked online but can't seem to find the...
I hyperdipped my emblem and it was fairly easy to do instead of 3D printing a new one. No problem with durability after +- 1 year. @priusasa What...
Grab it slightly after the curve begins on each end. It's just a plastic clip on each side that clips into the base. It requires some force but...
If you go the ebay route, always ask the date code! That's how I ended up with the brand new one. Listing had an old tire on it when I asked the...
They could also go the ebay route and find a pre-made set or a C-HR spare. I got a whole set and tools ~$200 and the seller even slapped a brand...
What are your other cables coming out of your connector? The ones I got are 2 pins only. Do you mind putting some more pics of the connector...
If you search for "2023 Prius hood strut" on Aliexpress, they'll have a few around ~ $20
Do you have a list you're considering for rear sway bar and stabilizer in the front? I remember talks about getting a thicker sway bar front/back...
Are your connector pins properly set? 1v is way too low. You should be around 5-6V. 1V would definitely make it near impossible to see even at...
Pre-tarrifs you could do it for about $5-600 in the US but it involved some risks of cracking the plastic. Now I'm not sure if prices have started...
Lease the car out and buy it out same week to take advantage of the TFS $4500 lease credit. I had to do this recently but it mostly went to the BS...
How's the trunk supposed to open from this model? You'd need to cut a piece where the trunk part opens and add support in the centre. A part that...
Sorry for the delay, I forget the notifications on here. I only have pics of the sides but for the centre, I pushed it flat all the way on using...
Just dental floss/fishing line did the trick for me but it was already hot out that day. Then you just clean off the adhesive left. If you want...
