Separate names with a comma.
I did all that 'registration' stuff & exchanged the 'credits' that came with the purchase for every additional function available. Since then I've...
OK, so I'll assume the resistance reading across Pins 1 & 4 is alright (although I don't know what the reading on a 'failed' heater should be)....
OK, I'll look for a Denso or NTK O2 sensor... may have to go to the dealer. Thanks for the advice! BTW: I get 800 mv on my scan tool (warm,...
Well, I bought an Autel AP2500E; installed the correct Autel App; initialized the unit w/ VIN, etc. for my 2008 Gen 2 Prius; downloaded the extra...
Thanks for the pin info. Scanner says I'm getting 0.8V (hot) from the sensor, and voltmeter reads 9.0 ohms (cold) across Pins 1&2 (heater) which...
Aftermarket. When the original Bank 1 Sensor 2 went south (approx. 35,000 kms ago) I bought a pair thinking I'd replace both O2s in the bank. But...
2008 Prius (172,000 kms) periodically triggered PO420, no exhaust leaks, good mileage, does consume some (synthetic) oil. PO420 became more...
Thanks everyone!
Thanks everyone! Q1: Are you using the App that comes with the Autel AP2500E (upgrade of AP 200)? Or are you using a different/better App? Q2: If...
Thanks for the guidance - much appreciated. Turned-out to be one of the rear wheel speed sensors in the wheel bearing hub. This forum is great!
Thanks for your reply! As mentioned, I have two Bluetooth readers and two Android Apps that are good for general ECU inquiries. But they're not...
Thanks for the link... my reading for the next few days. Much appreciated!
I've bought a Mini VCI cable w/ software and have spent DAYS going through every possible install & set-up; downloading other versions; following...
