Separate names with a comma.
Looks like the gasketmaster video is back online. One thing missing from that video is critical step of releasing chain tensioner after timing...
The explanation I heard somewhere (possibly from gasketmaster video) is that prius has powerful electric motor spinning the crank instead of a...
Yes that's a good point. Luckily I examined the piston carefully, but found no cracks or any other damage. The wrist pin is also identical on...
Yes you are right. The head gasket replacement video on 3rd gen prius is back online. It's also helpful to watch the gasketmasters video on 3rd...
Since prius engine is virtually identical to toyota corolla engines 1ZZ-FE, 2ZR-FE (except for being atkinson cycle), and corolla 2006+ all have...
Just completed a head gasket replacement and replacement of bent piston #1 connecting rod on my gen 3 prius V. There are lot of information out...
Looking at assortment of videos on youtube of the engine teardowns after blue devil and other sealant has been used, it's obvious it not only...
I removed head on my 2012 Prius, and head looks pretty flat using stiff steel ruler. But I will sand it (old skool method) on flat glass table...
Yes I would agree. My 2012 Prius also blew HG and consequent bent rod at 177K. Too bad, it was at Toyota dealership just two weeks before for...
I need to remove connecting rod for cylinder #1 on my 2012 prius. But taking a look at what's inside with oil pan off, there is no access to any...
Is it possible to just replace the bent connecting rod? For pistion #1, it looks like it should be possible to access the piston by removing oil...
Yes I found my 2012 prius piston #1 2 mm lower than piston #4. Looks like HG failed on cylinder #1 and dumped coolant, bending connecting rod on...
Yes on my 2013 prius V (175K miles) HG failed and it was cylinder number one. The intake manifold leading into cylinder number one was positively...
Yes too bad that video was taken down by gasket masters. I saw that video and it made it crystal clear to me what needed to be done and that I...
