Separate names with a comma.
Thanks everyone for the feedback. After a bit of messing around, I was able to get my scan tool to bleed the brakes and everything works great...
I have a parts car, so just decided to change both while I had things apart. Not the worst job in the world. 2 hours including pulling the parts...
Hi All, I just finished putting an engine in a 2011 Prius I bought with a blown engine. First startup was this afternoon and I quickly realized...
Wanted to follow up on this. After junk yarding 4 high voltage fuses so I could troubleshoot the system, I wasn't able to get the fuse to blow...
Do any of you know what else this high voltage fuse might control? Is it just the A/C or does it control the water pump as well?
The car has 217k miles on it. Yes, I was using R134a.
I got the codes from reading the info display after the AC/Recirc hack. I have not read codes with any other scanner besides the Dr Prius app.
So I'm in the process of resurrecting a 2011 Prius that was sitting behind a repair shop for 5 years with a hole in the block. I replaced the...
I'm finally ready to put this battery back in the car. I did a 48hr balance and then 2 minute load test for each cell and each one measured either...
Hi Seymour, thanks for replying. Would you mind sharing the process you're using to recondition modules? Have you been able to get the charger to...
I literally just did this yesterday on my 2011. You'll need to remove the plastic keeper that doubles as a support for the fuel line. A little...
Ok, so I feel like I need to reassess my approach to this battery. I've run 4 discharge/charge cycles so far, with the discharge to 6.0v and the...
@Carall, When you say "discharging the entire battery to 5 Volts or lower", do you mean all 28 cells connected together as a unit discharged to...
