Separate names with a comma.
Did you properly tuck the front/leading edge of the lower cover under the bumper cover when it was installed? If the cover's front edge was...
Did you hear anything prior to getting this message? Some people reported hearing a "bang" when the IPM or transistors go. Also, how's your...
I usually see at least one driver a night driving with only DRLs with absolutely no lights on in the rear end of the car. The drivers are also...
Actually, I think I posted the wrong pictures. They are of what came out of the Prius with 124K on the odometer. The used cooler I got off eBay...
Nice work, as a hobbyist woodworker, I am impressed by the fabrication techniques and pins used to make this platform fully functional, yet allow...
I also wouldn't be concerned about the knick on the intake manifold on either side of the orange gasket. The new IM gasket on reassembly will make...
The "broken" bolt or screw you are concerned about, is supposed to look like that. The side that looks broken is a locating pin or nub, the sensor...
Sorry, no. The wheels from a third gen look like this, they are from my third gen 2011 Prius. The 4th gen wheels are better looking, IMO. The...
Our 2011 Prius plastic oil filter housing was on so tight I had to resort to using a 1/2 inch corded impact gun to remove it. It was torqued down...
Make sure you use really hot water for the rinses post soaking in the sodium hydroxide. And then flush with lots of water. SM-G781V...
My attempts at using spray on oven cleaner was futile, the EGR cooler was too clogged. The oven cleaner only penetrated the first half inch or so...
You never said anything about using the stock tires on the new rims. Just if the new rims would fit. [emoji849] SM-G781V ?
Also, my previous Enkei wheels had some small diameter holes for the lugnuts, so I had to use slim lugnuts, if that makes any sense. Gorilla...
There is a rubber grommet near the brake pedal in the firewall you can push wires through. See attached installation file in the first post in...
The specs look OK, you just need hubcentric rings to adapt the larger bores on the wheels to your hubs. Something like these:...
