Separate names with a comma.
Erasing the code didn't fix the problem, you just made your car unaware that there's a problem so it will treat your hybrid battery as if nothing...
First thing the mechanic should have done is a system scan of all computers for current faults. What are the codes?
It will read/scan Engine Control Module for stored/pending/current codes on all makes and models (1996 and up), with custom PIDs loaded (google...
I had the same problem once I started doing more than 1 battery at a time. The solution wasn't available to buy, yada yada yada and I ended up...
Without proper equipment and capacity testing modules it depends on how good your old pack was and how good the part is that you're putting in,...
Sorry to be the bringer of bad news but P0A80 indicates a cell failure within the battery pack. What you did is essentially clearing the codes and...
Agreed! Part number 82165-47040 "Wire, Frame, NO.2"
Look into Caswell plating, they offer a basic kit to get you started.
None. Gen 3 is a lot better at battery management than Gen 1 and 2. Most failures of Gen 3 batteries that I have seen have been due to heat, the...
Here's some of my first hand experiences with this problem. The first two images coincide, codes with the battery, this car would not go into...
After about 1-2 months the bad modules blow up and the car suddenly shuts down.
Sorry to inform you but will corrode within weeks, see attached. That's a harness that has been in service for only 4 months after thoroughly...
I guess I've hit some sort of a limit, no matter how many times I attach the picture it won't post. IMGUR to the rescue! [IMG]
I've had P3030 code thrown from an ECU with corrosion on a few pins. See attached picture.
Got my hands on a sample batch of these connectors and replaced it on a battery computer that was working fine but had corrosion on the pins, will...
This happens in stages. Stage 1 corrosion builds on the sensing harness and battery ecu pins Stage 2 corrosion bridges 2 pins together causing a...
That would probably create a new set of problems, particularly with packaging since there are 2 rows the wires would be laying one on top of the...
I see this problem all the time in Oregon, it is caused by corrosion on the sensing harness plug and battery ECU. This needs to be addressed...
All connections must be properly tightened, it's not about one cell or two cells, it's a break in the chain. Don't even attempt to turn on the car...
Vent tubes were being removed sometime in 2011 and all gone by 2012. Battery blocks are counted from the module which you attach the negative...
