Separate names with a comma.
Thanks Patrick No1. will refer and see, otherwise I'll use Toyota, dealer or other expert. No.2. Will find it in techstream and do it today if...
[1] C1451: need to bleed air out of the hydraulic brake lines I think this can be done at any local garage.. [2] C1345: linear solenoid valve...
C1203 C1345 C1451 pls find attached :(
.
Oh Noooo. at 11.4Km the lights came back and they refused to reset with OBD pin 4&13 reset... when again tried resetting at 13.2 km VSC, ABS, (!)...
Woops you're scaring me In Sri Lanka Vehicles are registered with chassis No and Engine No. VIN is not considered. So I can connect the dots of...
Woopps It's VIN - Vehicle Identification No You would have seen it's asking to input VIN every page left top.
certainly .. just now i did. pls see attached. always this reminds me i cannot find the VIC.. its not placed in standard places. do you know any...
Vacuum cleaned it, then used isopropyl available at home Again vacuumed to remove any cotton residuals Fixed the connector Went to ready mode,...
Or should I just try cleaning socket & connector well before connecting it. So what do you think the best way to do it
Ok guys Now I have to find a Skid control ECU or entire assembly And instructions to replace it because it was 62.3Ohms
Thanks loads Patrick, you're the savior.. !!! I switched on the car to see, whether its drivable as i have to come to work today. hopefully...
hi patrick i took the manuals from Toyota Service Information but there was nothing special for JDM. Does above attached connecter...
Thanks Patrick. May be I should check, is there a different manual for JDM model
Thanks bisco...
Couldn't find the pin 34 & 35 since didn't know how to start counting. The diagram was different from the actual. Pls see attached. Pls let me...
I thought it should be a neat work. With a plug fitting a socket. Now have to work through each wire... Wish me luck folks...
i know its been i while, due to travelling to US and back. the car didnt move at all while is was away for 10 days. and now the lights come up...
Couldn't find time still to do the remainder BTW, I was just looking for skid control ECUs on eBay and amazon there are lots available but all for...
Thanks Patrick, much appreciated I did remove the cowl and I think I located the actuator (picture attached above post). But couldn't locate ecu....