Separate names with a comma.
I don't think they're bolts. It's just one self-tapping screw going into plastic. I hope that helps.
My painter actually asked me the same thing. Painting a bumper protector makes it into a painted bumper :) I must say that the clearcoat helps a...
Rear bumper protector colour-matched: [img]
I found this for sale post: For Sale - Tanabe Z40 Coilovers 2010-14 Prius | PriusChat Tanabe Z40 with front camber plates: [img] [img]
Thank you very much for getting this out. I will definitely look into getting one once my foglights are installed. One thing though. Your...
Comparison of the stock horn with a set of Nissan horns I had lying around. Not noticeably louder, but better tone than stock. [MEDIA]
I looked again, and you're right. We'll have to go with eccentric bolts then.
FYI, 55mm is the inner diameter of the centerbore on the back of the wheel to fit the hub. On the centerbore on the front, you can see that it...
Techstream can do it for sure. There may also be a way to fidget with the buttons and controls in the car for the GenIII. I'm not sure.
The alignment shop is trying to figure out if there's enough room to adjust the camber plates without removing the wipers and cowl panel, and/or...
Toyota's newly redesigned engine block heater arrived today. It comes with the heating element itself, an extension cord, some zip ties/velcro...
Is there any way you can get better pictures of the HKS, especially of the camber plates? Thanks.
I have 3M trim tape that's amazingly strong. 10 years after soaking in the hot sun and it's still going strong. I also considered fabricating...
The bumper protector is an extra layer that's there not to just prevent scratching, but also to provide extra puncture and shock resistance to the...
Follow up from the other thread: Rear bumper protector fitment for '15 PiP | PriusChat I decided to get the Bushwacker rear bumper protector...
I got the car back with new tint. State legal 50/35. Even with 50% front it still appears quite dark to me, but the shop assured me it's legal. I...
If it's OEM then it's legal. Your LED is compliant with SAE/DOT standards, and each assembly would be considered to be 1 light. Now that just...
I think you've done your homework more than adequately in terms of pricing compared to the contents you get. At this point, it's more of an...
These are the typical cars the shop works on, and yet they still work on my car. Super nice guys: [img]
....
