Separate names with a comma.
Diesels currently require relatively drastic measures to meet EPA emissions standards like low sulfur fuel (as expensive as premium gas) and urea...
Well, they've delivered one: First Tesla Model S delivered to board member Steve Jurvetson - Autoblog
Tesla unveils details of Model S high power and flexible charging system Been to the Tesla "showroom" in Bellevue Square, and they new S looks...
I already used the nub for my fog lights. I'll have to make a new cut, but the rubber is thick as I recall. BTW, I don't think hooking up to...
Did you have to take off the wiper tray to get access to the grommet? I believe I had to when I did my fog lights. For power, I'd look at the...
I just got my kit today. Here's a picture of the contents:[ATTACH] The control box is smaller than I expected. The wire bundle with the yellow...
Components from Proxel for front proximity sensor
I think the spacers are for transporting the vehicle from the processing center to the dealer. You won't need them. The alignment specs are the...
Stock shocks, but my drop is about 1.5". Be sure to get your alignment checked after the spring install.
Also, to check the fluid level, the car has to be level, so both ends up in the air and the chassis level.
I've looked at the manual, and the tricky part is refilling/purging the radiator. That takes a dealership computer to turn the pump on. Not sure...
You can get the rear sway bars two ways - one with the end links and one without. There are different part numbers for each.
This was north of Northgate, around Montlake Terrace, and I couldn't see the plates given the barrier between the southbound and northbound I-5 lanes.
There's no problem going from the lower bumper to the engine compartment. You'll have to look for yourself. I ran my fog light wiring across the...
On I-5 Southbound this morning, I saw a dark grey Gen II Prius with police lights flashing (blue/red) driving in the carpool lane. It looked...
Go to another dealership. There are good and bad Toyota dealerships, and the one you're dealing with just doesn't give a damn.
I don't think you have to remove the front bumper, just the black panel on the bottom just behind the bumper. Assuming you're putting the...
I finally ordered mine today - had to wait for PayPal to be reloaded.
The brace is to keep the two strut mounts from moving independently. Do all the work with the car on the ground. I could point you to some good...
You really won't get go-kart handling until you also put in a front strut tower bar. What you have in mind will be an improvement.
