Separate names with a comma.
Getting code P0121 now along with the P0A0F and no start. We have put in 3 different throttle bodies with 3 different TPS so unlikely the issue...
What I have read here does not make them greatest amount of sense to me to change out your fuel tank. I have owned several generation two and,...
Got it running today. Removed and replaced the 12V battery, which was marginal. Now the car will go into READY mode and the engine will...
Is it the one to the far RIGHT of the passenger side under glove box?
Car will NOT go into READY mode... when trying to start engine after clearing codes with TS. It immediately throws code P0A0F along with with...
What about a whole assbly from a junk yard? Is there a need to run utilities to reset it?
Thank you Electroingenieur, I think I am on the right path at this point. According to the most recent code ( along with PA0AF) is the code...
Chappy, that’s all great and thank you! I’m trying to get the bigger running again! What happens is: I clear codes, spin engine, no start, code...
Ozmatt, I realize the difference between engine spinning and actually starting. I tried the starting fluid in the throttle body and yes, the...
Thanks for your response Electroingenieur! I won't try to pronounce that. The code previous was P0121which Does not seem to appear any more......
Following this discussion... Did anyone find a solution? I have an '07 with P0A0F/205 and I am pulling my hair out. IU have tested...
Voltech444 what was the problem? What was the fix? Thanks
I am very curious about theses things because I like to recycle parts sa much as possible. Of course we all know what the dealer is set up to...
Thank you Sir Chapman! That is entirely good information. I went into the test mode to verify theses numbers and yet, i still had the pending...
Apologies for not clarifying.... this is for a friend's Gen 2.
Obiejon12. Did you finally fix it? Did you have to replace the ABS actuator? I have the same issue right now…
I went out and tested the '10 again today. I did not use the active test. I just cleaned the MAP and MAF and put it back together and watched....
Thanks BZzap! Peter Neilson has been helping me with the problem for over a month now.... obviously, we have not been successful! Not even a...
I drove the pattern for a minimum of 5 minutes and then stopped the car and read the DTC judgement: first couple of times it said INCOMPLETE and...
Yes, Sir Chapman I did try the active test on the step motor. And yes, it did move from 4 psi to about 7 or 8 when i got into the 20th step or...
