Separate names with a comma.
I replaced the skid control ECU again..... Checked codes today and along with VSC light being on constantly, I get the old UO126/350. Brakes work...
I just finished with the TS brake bleed process. All went well after 2 or 3 tries... The UO126 code magically disappeared. Now I have C1203...
I have replaced my actuator ( '05 with 123k miles) with a known good used one and I get the 2 codes mentioned above: C1345/501 and U0126/350....
I have an extra capacitor ( 220 micro farrad that i replaced the original 100 microfarrad capacitor with) and all is working fine. It is a known...
Am I wrong in assuming that Toyota fixed the problem with the combo meters by 2008? Reason I ask, I am working on a 2009 and While driving...
It sounds to me like your battery is a bust.... should not go all the way to one bar. Use techstream to read codes. As far as the P0420 DTC,...
New Update: Clock and radio and courtesy lights now working. I tried replacing the MFD, but got the same reults. Here is the process... Although...
OK I took off the door panel because I wanted to look at all the wiring that goes through the door grommet, etc., because THAT seemed like the...
I have replaced the driver's side pad from a known working vehicle and still the same result... blown fuses on both the mirror and the door...
I have a 2009 that belongs to a friend that I was working on for her... Just doing little stuff to help with her maintenence issues. I had...
Don't know how many miles on it.... can't get dash to light up. I am using TSI. IT will NOT go into diagnostic OR ready mode, so tech stream is...
I have question for master Patrick Wong, if he is so willing... I have a friend with an '06 that was dead on the road, ostensibly because of HV...
Any luck Jerry G?
Jim Caldwell, I am having this code C1365 as well... Did you manage to get it fixed without going to the dealer? I would love to have some help...
OK, Some help asked for here please. I have, to the best of my ability, determined that the intermediate shaft and the 2 u-joints are fine but...
OK assuming it is the intermediate steering shaft that needs to be replaced, is that doable without taking apart the steering wheel or not? I...
padroo, tie rods were just replaced!
I tightened the 3 bolts visible from underneath the dash... IE, the only 3 -12 mm bolts as part of the intermediate shaft that are visible from...
Aloha The Critic. I have a steering problem in my '07. Slight rattle at slow speeds. Had the inner tie rods replaced and car aligned which...
Did you do a continuity check on the sensor wire for that block 12? Your sensor wire may have a break or a crack in the tab that causes the...
