Separate names with a comma.
FAQ: KYB Americas | The Differences Between Monotube & Twin-tube The strut assembly uses the Excel-G strut which are twin-tube construction.
Used these to replace the rusty OEM's: Front: WAGNER BD180387E Rear: WAGNER BD126558E Black E-Coat on non-braking surface to prevent rust and...
Finished replacing the struts and shocks. Tools that were used included: - floor jack - 6 feet cheater bar - 1/2" impact wrench - 3/4" torque...
[ATTACH] For comparison: After 100K miles on a '12 with 212K miles.
Got it now. Went ahead and installed with the 3 top bolts finger tight. Twisted the bottom strut to the right orientation. I've done strut...
I'm in the middle of replacing the front struts and not off to a good start. The two knuckle bolts needed a combination of an abundance of PB...
Just researched this and ordered the parts from RockAuto. Part Number, Part Type, Quantity KYB...
I got caught up in the Wisconsin rain on the way home Tuesday with my Prius. Interstate was closed so I made a really bad decision and tried...
Oxiclean is highly rated. Soak in very hot cleaning solution overnight. Rinse with very hot water. Best to have a utility sink to force water...
check the 12V battery. a bad one will keep the ICE running and not show any codes.
Low mounting works for me along with a remote drain valve. No need to take the bottom panel off for draining. After using the OCC over one...
My 2012 is still going strong @191K miles. I'm going for 500K miles before retiring it. Suggest addressing the age related issues first (those...
Update on the OCC install after 13K miles. The epoxy bonded bracket mounted to the lower cross member is working out fine. It has survived a...
Changed pads for the first time at 184k miles. Old pad measurements in mm: front pad new replacement: 9.5 front left outer: 3.9 front left...
How many miles? Was the EGR cooler/intake manifold ever cleaned? I have the same year/model @183K with no head gasket issues to date.
An assortment of needle nose pliers shown below. The two with ends made for hoses was a huge time saver. They help to loosen and once the plier...
I just completed cleaning the EGR cooler and valve along with the intake manifold for the first time at 178,000 miles. You really do not want to...
Good point. I did need to lower it off the jack so it has seen one jack cycle. Properties of adhesives vary a lot. In my day job, I design...
Some photos of an OCC install. This installation locates the OCC off the lower cross member, but, does not require drilling holes and locates the...
Just to clarify the March 31st 2017 date in the first post is unique to the purchase date of that vehicle. My purchase date was March 2012,...
