Separate names with a comma.
20 minutes with a pressure washer and engine cleaner and labor would be too much? What is his labor rate?
I was told that it was in the service intervals at about 150K covered under exhaust emissions. I could see through parts of the EGR, but not all...
Best and easiest (and messiest) solution for the intake is a can of engine cleaner, a pocket full or quarters, and a car wash. The quarters and...
Judging by the remnants it looks like you did the inverted electric slide. Glad you weren't hurt any worse.
I'm from Zebulon and there is another poster from Little Washington. I'm also thinkin' there is one from around Charlotte/Matthews.
Naaah, I was gonna get the adviser to walk me back to look at it.
When I went back for recall, the service "adviser" advised me that the mechanic had advised her that the air filter needed to be changed and that...
I kept getting turn by turn directions so I turned off the radio and it continued. Then I turned off the cell phone and it continued. Strange...
It you can get a couple of good pics, I can see if it matches the ones on my Gen4 harness. It should as I didn't change any sensors on my swap and...
Vacation mode is when we attach the dolly to the coach and strap the Prius onto the dolly. ;)
To implant a Gen4 engine, you have to reuse the Gen3 EGR system and intake. At least two of use had to transplant the flywheel and damper, and I...
All the jack in the box parts stores will have a display with plastic packs of them. You can take one in and match them. You can probably match it...
At what point should a manufacturer be responsible for a later detected issue? 100K, 125K if one of those are fine, wouldn't 200K be better, and...
Check to see if yours is subject to the headlight wiring recall. Ours was constantly going thru right side (iirc) headlight bulbs and marker...
Plastic tree things? Are you asking about the plastic panel rivets?
Coolant loss isn't always consistent with a head gasket failure. Ours went thru almost a gallon it just over a week, but since the problem became...
??????
Why does finishing the IV to III engine swap bring this to mind?? [MEDIA]
IIRC, The Mann filters are built in Germany to German standards.
Mine? Nope.
