Separate names with a comma.
post script: I pulled the brake off and cut little lines around the axlenut dent, using a small cutoff wheel on a dremel tool. Then driving a...
a cutoff wheel- the disposable kind that screws onto a little mandrel thing. I ran it on the edge of an old hammer for a while til the diameter...
2002 prius here, with a bad LF wheel bearing. I got a new axle nut from the dealer and used a dremel tool with a little cutoff wheel to score...
Hmmm, it doesn't seem to vary as much with braking as it does with swerving. For example, if I am going 35-40mph and make a pronounced turn the...
I think it is a wheel bearing, although I have NEVER had a wheel bearing do this, and I have been driving the s*** out of frontwheel drive cars...
ok, I replace everything from the antenna down, and see if the noise goes away. Any OTHER ideas?
How about a solution like this: Catalytic Converters - Auto Parts Warehouse which is a link to a catconv that claims to be an exact fit with no...
Huh. Doofus here relied on the phone call to the parts store- when I looked it up in their catalog the wheel bearing wasn't any ten bucks at all,...
I have a 2002 prius 220,000 miles, and I am faced with a front end hum that changes when I turn or swerve. I am assuming it is either one or both...
wow- the price for halfshafts from O'reilly's is around $80 or so after the core return. I am wondering if it is a wheel bearing instead. How...
I looked at both cv boots on the wheels, but not the inside ones. In my experience, the inner boots last soooo much longer than the outer ones,...
Thanks Bob, I am very comfortable measuring voltage. I have done it before with needles through the insulation then a little silicone over the...
I can't decide if I should worry or not. Is there anything else I can do? I suppose I could put new tires on again and see if it goes away. I...
2002 transaxle noise question/diagnosis My 2002 Prius needed tires about 10,000 miles ago and I knew that. The rear ones were kind of scalloped...
How did this go? Any problems- did the vacuum thing work ok? Would you do it over again this way if you could go back in time? Thanks, Joe
