Separate names with a comma.
Daox do u have a schematic ? or just a sketch ? i was thinking of using 3 relays, 2 to detect the alarm from the two cellog; as each is at a...
I would not trust the Enginer voltage monitoring of the whole pack as a very good cut off. I trust the Cellog monitoring of the individual cell...
I think it's worth the effort to run separate pair cable from the Motcell pack to each converter, as each converter can draw 60A of 48v. Plus you...
Dan - no, my kit does not have this exhaust ducting. I know exactly where the rubber flap is and I was thinking of doing exactly that; but I...
Dan - no, what 6 in plastic tubing ? what is the tube diameter ? is it part of the kit ? I am also seeing the pack is very well balanced,...
Dan - that's a good idea to tap at the cellog cable. I am a bit leery of closing the lid completely; as the converter get pretty warm, more than...
Dan - do you have 2 independent sirens, each connected to its wn cellog 8 ? I may have zapped the open collector on one of my cellog. It dawned...
i thought of that; but my problem is my laziness. I should re-wire like Dan to raise the voltage for faster draining. Even with a cloth dryer...
I think it's going to work very well. I have plan to make my kit plug & play as I can be an idiot at time. It has to be idiot proof. Plus my...
I don't think you mean "daisy chain" in series right ? You would be paralleling them to the stock pack. I was looking for the wire gage size...
Yes, it does look quite promising; thanks for sharing your finding Dan. In response to this message from the other thread: /* You put 32 cells in...
Dan - good idea, I'll post in Balance at the bottom thread thanks - Paul
Dan - thanks for the 3prong idea. I'll keep that in mind. I checked the converter open circuit voltage and it's at 233.8v, a little low from...
Ok, I'll contact Jack. I think my converter may not be charging agressive enough as it takes a long time to get another increased bar. How long...
may be you can post it; since I would like to set my 2 converter set points as well. thanks, Paul
This is a good point. So you only had to bottom balance your pack once so far ? I guess the premise here, as well as from Richard @ EV...
hi Banshee08, did u have a bad experience with Chargery balancer (DB8) ? I was thinking that it can serve as a bottom balancer as well as a top...
The rcgroups has been evaluating the CellLog8S the last 6 months and have loads of info and tip. I recommend reading up at the link below....
Dan - It may be problematic using the 4 balancers as connected for effective 16-cell pack. There are 2 balancers connected in parallel. My...
Daox: thanks for the info. As expected, the pack is essential dead weight on long trip. I am planning to come up with an easy to remove/replace...
