Separate names with a comma.
X2 Run D>C at 1A then charge back at 2A (5A is way too high IMHO).
Great job but make sure to spend the money on a Prolong charger setup, worth every penny if you want to keep that new battery functioning at max...
I find that if you ever need to buy a salvage battery you are best off getting a low mileage one from a rural very cold climate (AK,ID,MI,MN,MT,...
If you have any question on which is the bad module you can just check the voltage and run a load test to identify which aren't performing properly.
Don't buy modules off ebay, chance of getting bad ones again is very high........buy them from this guy ^^^^^^^ I also agree though, if you need...
If you are going to carry it around in the vehicle then Scangauge, if you want just a code reader, you can't do better than a mini VCI setup (same...
Same here, well worth the money whether you have a new HV battery or an old one you're trying to keep going.
I never wear any jewelry wrenching after I saw a fellow mechanic working on a battery post with a wrench in his left had accidentally bridge the...
Modules probably need to be grid charged then load tested to ensure all is well of that battery was recently rebuilt.
Not a big fan of using anything to flush the engine oil since removing alot of crud at once can cause some issues, definitely prefer to just use...
Matt, you're right, I meant to say sealed (both AGM and SLA) batteries are required when inside the cabin.
Anytime the battery is located inside the cabin you should always be using a sealed style battery, without exception and for exactly the reason as...
As long as the file locations are right the TIS should run in compatibility mode as an administrator on any 64-bit machine without issue, the...
Great data, can you post up the settings you were using on the Hitec chargers in case someone wanted to try it later?
The issue with windows 8 and 10 are obviously the drivers typically being only 32-bit trying to run on a 64-bit operating system. As Jeff...
If you have a mini VCI look at the charging voltage on your AUX battery, if it's too low it will kill the battery over time.......you should see...
Yeah, those are good too (oil filter pliers look just like that) but I like channellocks because you get more leverage (20" handles), they are...
First replacing single modules in an older HV pack with success either takes alot of skill or alot of luck (remember gambling is an expensive...
Technically they are called tongue and groove pliers but the trade name is channellock just like folks ask for a Kleenex or Band-aid. Attached a...
I use a pair of 20 in channel locks for oil filter changes, I haven't seen an oil filter I couldn't remove with those (including big diesel filters).
